DA6344/DA6345 Britpart +50mm Suspension Lift Block Kit

If you are ready to add a full 50mm (2 in) of lift to your classic Land Rover in one shot, the Britpart DA6344/DA6345 +50mm Spring Spacer Block Kit gives you everything you need in a single purchase. This kit bundles the DA6344 front pair and the DA6345 rear pair together, delivering a complete front and rear lift solution that installs directly between the axle and the factory spring seats at both ends of the vehicle. The result is a balanced, level 50mm (2 in) height gain across all four corners without the complexity or cost of a full suspension overhaul.

Every block in this kit is fabricated from 6mm (0.24 in) thick steel plate and finished in a durable powder coat designed to hold up against the mud, water, and general abuse that Defenders, Discoveries, and Range Rover Classics are routinely asked to handle. Britpart has been supplying the Land Rover community for decades and backs these components with a 24-month guarantee, giving you confidence that the hardware will perform over the long haul.

Installation requires no cutting, no welding, and no modification to your existing suspension components beyond the intended lift height change. The blocks locate cleanly into the existing spring seat positions at both axles, making this an accessible job for any owner comfortable with basic suspension work. Because you are raising the vehicle ride height at both ends, a full four-wheel alignment check after fitting is strongly recommended to confirm that steering geometry and handling remain within safe and accurate specification.

This kit is a popular choice for owners building a light off-road setup, adding ground clearance for overlanding, or simply restoring a balanced ride height to a classic Land Rover that has settled over the years. Pairing these spacer blocks with uprated shock absorbers will maximize the benefit of the added lift and ensure proper suspension travel at both axles.

Fits:

• Defender 90 (1983 to 2016)
• Defender 90 NAS (1993 to 1997)
• Defender 110 (1983 to 2016)
• Defender 110 NAS (1993 to 1997)
• Defender 130 (1984 to 2016)
• Discovery 1 (1989 to 1998)
• Range Rover Classic (1970 to 1996)
  
  
  

Part Number: DA6344/DA6345

Free shipping to the lower 48!

No supersessions found.

FAQ

What is included in this kit?

This kit includes four spacer blocks in total, two front blocks sold as DA6344 and two rear blocks sold as DA6345, giving you a complete front and rear lift set for your Defender, Discovery 1, or Range Rover Classic. No additional spacer hardware is required to complete either axle installation.

Will I need longer shock absorbers after fitting this kit?

Adding 50mm (2 in) of lift via spacer blocks increases the droop travel demand on your existing shock absorbers at both axles. Depending on the condition and specification of your current dampers, uprated or extended-travel shocks are worth considering alongside this kit to maintain proper suspension articulation and get the full benefit of the added ride height.

Can I use just the front or rear pair from this kit without fitting both?

While each pair functions independently, fitting only one end will result in an uneven ride height and altered vehicle geometry, which is not recommended for regular use. For a safe, balanced result this kit is best installed as a complete front and rear set, which is exactly how it has been packaged here.